| 木门工艺流程 |
| 添加时间：2019/8/7 16:09:49 浏览次数： |
| 1、 [3] 木料干燥 1. [3] Wood drying 进厂的原料板材（含水率约为60-70%），装入干燥窑进行喷蒸、干燥。板材质地、厚度不同，季节不同，喷蒸干燥的温度、时间及稳定的时间也不同。一般喷蒸的时间约15min，加热干燥的时间约25-30d，干燥后的板材含水率约10-14%。 The raw materials (moisture content is about 60-70%) are put into the drying kiln for spraying and drying. The temperature, time and stable time of spray drying are also different for different materials, thicknesses and seasons. Generally, the spraying time is about 15 minutes, the heating and drying time is about 25-30 days, and the moisture content of the dried sheet is about 10-14%. 喷蒸及加热干燥用蒸汽由项目新上的4t/h燃煤蒸汽锅炉提供。加热干燥过程中，根据工艺技术控制要求，需不定时打开干燥窑排潮窗，排放干燥窑内的蒸气。 Steam for steam injection and heating and drying is provided by the new 4t/h coal-fired steam boiler of the project. In the process of heating and drying, according to the technological control requirements, it is necessary to open the drying kiln dehumidification window from time to time and discharge the steam in the drying kiln. 2、下料： 2. Cutting: （1）粗裁时，长宽各加大10mm；（需修整） (1) When roughing, lengths and widths are increased by 10 mm each; (Need to be trimmed) （2）如组合下料，注明木皮材质，标明何种门型组合； (2) If combined cutting, indicate the material of wood bark and the type of door combination. 3、组框 3. Block （1）四角方正，长宽各加大10MM (1) Square corners, 10MM longer and 10MM wider （2）外框宽度规格为800-2000MM，表板为6MM中密度板，中间填充邵尔兰特中空创花板。 (2) The width of the outer frame is 800-2000MM, the surface is 6MM medium density board, and the middle is filled with Shawlland hollow wound board. （3）加锁木，也可用锁盒。 (3) Locking wood or lockbox can be used. （4）组框时如是玻璃门，确定玻璃大小及位置 (4) When the frame is assembled, if it is a glass door, determine the size and position of the glass. （5）骨架做防变形处理后，上压机压平 (5) After anti-deformation treatment of the skeleton, the upper press is flattened. |
| 上一页 木门选购 |
| 下一页 木门分类 |
Copyright © 技术支持：遨游网络